Wiring Diagrams Figure 4. Check after Installation and Test Operation Items to check Possible problems they generate The unit may drop, shake or emit noise. Don’t have an account?
Enter text from picture: Wall structure must be adequate to support the manauls of the unit. If a system has been open to the atmosphere for more than 4 hours, the compressor oil must be replaced. General Information Warranty manuls based on the general terms and conditions by country. Trane has always recommended installing Trane approved matched indoor and outdoor systems.
Warranty is based on the general terms and conditions by country. Use a leak test solution or other approved methods for leak testing.
Trane R-410A Installation Manual
Failure to disconnect power before servicing could result in death or serious injury. Trane Ra Owner’s Manual 27 pages.
Explosive conditions may occur. Installation Take out the piping from body case, wrap the piping electric wire, water pipe with tape and put them through the piping hole. Never use an open flame to detect gas leaks. Got it, continue to print.
Trane Furnace Installation Manual
Wiring Diagrams Wiring Diagrams Figure 4. Page 11 Installation Take out trabe piping from body case, wrap the piping electric wire, water pipe with tape and put them through the piping hole. Hang the mounting slots of the mauals unit on the upper tabs of the rear panel and check if it is firm enough. Remote split system units air cooled condensing units and evp chillers 68 pages. Comments to this Manuals Your Name.
Don’t show me this message again. Failure to follow recommended safe pd test procedures could result in death or serious injury or equipment or property-only-damage.
Free Trane PDF User Manuals Download & Preview – testkey
The benefits of installing approved matched systems are maximum efficiency, optimum performance and best overall system reliability. The warranty is void if the equipment is modified or repaired without the installlation approval of The Trane Company, if the operating limits are exceeded or installqtion the control system or the electrical wiring is modified.
Failure to ensure adequate structural support could result in unit falling from its location which could result in death, serious injury, or equipement or property-only damage.
Only qualified technicians should perform the office or e-mail us at comfort trane. If the hole is not straight and uniform, this could result in installayion leaking from condensation, resulting in property damage. Disconnect all electric power, including remote disconnects before servicing. Instllation pressing ‘print’ button you will print only current page. The maintenance and troubleshooting procedures recommended in this section of the manual could result in exposure to electrical, mechanical or other potential safety hazards.
To print the manual completely, please, download it. April Supersedes www. Always refer installatjon the safety warnings provided throughout this manual concerning these procedures. It may cause insufficient cooling heating Have you done the refrigerant leakage test? NOTICE If a wall sleeve is not mounted in the wall, the wiring between mamuals indoor unit and the outdoor unit can possibly be damaged resulting in electrical current loss in the ground The air inlet and outlet should be far away from anything that could prevent the air from reaching all parts of the room.
Has the indoor unit been firmly attached? Page 20 April Supersedes www.